Lenovo ThinkCentre M90p Maintenance Manual page 51

Diagnostic Error Code
000-038-XXX BIOS Extension failure
000-039-XXX BIOS DMI data error
000-195-XXX BIOS Test aborted by user
000-196-XXX BIOS test halt, error threshold exceeded
000-197-XXX BIOS test warning
000-198-XXX BIOS test aborted
000-199-XXX BIOS test failed, cause unknown
000-250-XXX BIOS APM failure
000-270-XXX BIOS ACPI failure
001-000-XXX System Test Passed
001-00X-XXX System Error
001-01X-XXX System Error
001-024-XXX System Addressing test failure
001-025-XXX System Checksum Value error
001-026-XXX System FLASH data error
FRU/Action
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 98
2. Adapter card
3. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 98.
2. System board
Information only Re-start the test, if necessary
1. Press F3 to review the log file
2. Re-start the test to reset the log file
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
1. Make sure the component that is called out is
connected and/or enabled. See Chapter 6 "Using the
Setup Utility program" on page 39
2. Flash the system and retest. See "Updating (flashing)
BIOS from a disc" on page 98
3. Go to "Undetermined problems" on page 64
1. Go to "Undetermined problems" on page 64
2. Flash the system and re-test
3. Replace component under function test
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 98
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 98
2. System board
No action
System board
System board
System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 98
2. System board
1. Flash the system. See "Updating (flashing) BIOS
from a disc" on page 98
2. System board
Chapter 7
.
Symptom-to-FRU index
45