Casablanca Star Owner's Manual page 9

INSTALLING THE HALOGEN BULB
IMPORTANT! When installing the halogen bulb,
carefully cut off the end of the plastic sleeve the
bulb comes in and hold the bulb by the plastic
sleeve to screw it into the socket.
Step 10. Screw the 75-watt halogen bulb into the
socket. Do not touch the glass bulb with your fingers
it is extremely important that the glass be clean. If it
is accidentally touched, or dirty, clean carefully with a
tissue. A dirty glass will cause the bulb to fail almost
immediately.
HALOGEN BULB
NOTE: In compliance with US Federal Energy
Regulations, this ceiling fan contains a device
that restricts the light fixture to a maximum of
190 watts. Exceeding that limit or the marked
limit on this product may result in a fire hazard
or improper operation.
INSTALLING THE GLASS SHADE
Step 11. Position the indentations in the outer rim
of the glass shade so that they line up with the tabs
on the inside surface of the fan light fixture rim.
Carefully lift the glass shade up inside the light
fixture as far as it will go.
Rotate the shade in a clockwise direction until it is
held tightly in place by the three tabs.
TIP: At first the shade is a very loose fit in the
fixture and can be 'wiggled' a little from side
to side. It is a great help when rotating the
glass shade to 'wiggle' it at the same time.
S / S
™
tar tarlet
LIGHT
SOCKET
TAB
™
HALOGEN
BULB
GLASS
SHADE
GLASS SHADE
INDENTATION
9