DURKOPP ADLER 367 Operating Instructions Manual page 35

Action
In mid-seam
Interrupt
action
Continue
action
(after pedal is released)
Sew
intermediate bar tack
At the seam-end
Remove the material
Do not sew an ending bar tack
Subclass 367-170315; -180315
36
4
Operation / Remarks
- Release pedal (neutral position).
The machine halts in position 1 (needle down).
The sewing feet are down.
- Push pedal forwards.
The machine sews at the speed set by the
pedal.
The starting bar tack is not sewn.
- Press key 2 and hold the pedal down.
The machine sews backwards as long as key 2 is held down.
The speed is set by the pedal.
- Push pedal fully back and hold it there.
The ending bar tack is sewn.
The thread is severed.
The machine halts in position 2.
The sewing feet are raised.
- Press key 3 (bar-tack suppression).
Push pedal fully back.
The ending bar tack is not sewn.
The thread is severed.
The machine halts in position 2.
The position of the sewing foot depends on key 4 on the
operating panel:
a) On: - sewing foot raised.
b) Off: - sewing foot down.
- The 2nd Stitch length key 4
- The 2nd Thread tension key 5 *) can be at any time
switched on or off.
*) *)
1 2 3 4 5
*)
and