Reducing The Maximum Rotation Speed; Fast Information Display And Settings Entry (Hit); Entering The Technician-Level Code Number; Seam Programming With The V820 Operating Panel - DURKOPP ADLER 367 Operating Instructions Manual

7.3.5

Reducing the maximum rotation speed

7.3.6

Fast information display and settings entry (HIT)

7.3.7

Entering the technician-level code number

7.3.8

Seam programming with the V820 operating panel

28
The maximum speed can be reduced to adapt it to particular
applications.
After each completed seam the current value of the maximum speed is
shown in the display. This value can now be directly changed with the
"+" and "-" keys. The adjustment range lies between the values of
parameters F-111 (maximum value) and
F-121 (minimum value).
Caution !
Reducing the maximum rotation speed also reduces the rpm for
starting and ending bar tacks and for counted seam sections
executed automatically.
When functions are switched on with keys 1, 2, 3, 4 and 9 the
associated values are displayed to the operator for about 3 seconds.
During this period the value can be changed immediately with the "+"
or "-" keys.
CAUTION !
The changed parameter values are not saved unless a complete
seam is sewn after leaving programming level, i.e. the pedal is
pushed forwards and then all the way back.
If the drive is switched off straight after leaving programming
level, the changes are lost.
See set-up instructions.
A maximum of 8 programs with a total of up to 40 seam sections may
be saved.
The starting-bar-tack, ending-bar-tack, stitch-count, thread-cut and
foot-lift functions can be individually assigned to each seam.
For a description see the "EFKA DA82GA" operating manual.