Meaning Of Symbols On The V820 Operating Panel; Changing Operator-Level Parameter Values - DURKOPP ADLER 367 Operating Instructions Manual

7.3.3

Meaning of symbols on the V820 operating panel

Symbol Function
C Abbreviation C for the code number
D Abbreviation F for the parameter number
E Program number in teach-in mode
F Seam-section number in teach-in mode
G Cut-out active
H Entry via keys blocked
I Error message
J Stitch-rate entry in teach-in mode
K Bobbin-thread monitor on
L Speed limit effective
M Right needle switched off
N Equalising stitches for light barrier
O Machine running
P Automatic rpm effective
Q Left needle switched off
7.3.4

Changing operator-level parameter values

–
Turn on the main switch.
–
First press the "P" key, then the "E" key. The first operator-level
parameter value (Arv 002) is displayed.
–
Press the "+" or "-" key to change the value.
–
Press the "E" key. The next parameter value is displayed
or press the "P" key to save the change and leave programming
level.
Display
Symbol on when a code is displayed, e.g.
C 1907
Symbol on when a parameter number is
displayed e.g. F - 111
Symbol on when a sewing-program
number is displayed
Symbol on when the seam-section
number of a sewing program is displayed
Symbol flashes on active cut-out.
Symbol on when entry via keys is
blocked.
Symbol on.
(See section 7.5 for fault list).
Symbol on when the number of stitches
in a seam section is displayed.
Symbol flashes when bobbin is running
out
Symbol on when one of the possible rpm
limits is effective.
Symbol on when the right needle bar is
switched off.
Only on machines with automatic
needle-bar switch-off.
Symbol on
Symbol on
Symbol on when a seam section in a
sewing program is being automatically
executed at constant rpm.
Symbol on when the left needle bar is
switched off.
Only on machines with automatic
needle-bar switch-off.
27