Replacing The Hard Disk Drive - Lenovo ThinkCentre M80 Hardware Maintenance Manual

10. Hold the new optical drive and pivot the drive bay assembly upward. Align the screw holes in the new
optical drive with the corresponding holes in the drive bay. Then, install the two screws to secure
the new optical drive in place.
Figure 66. Installing the optical drive
11. Connect one end of the signal cable to the rear of the new optical drive and the other end to an available
SATA connector on the system board. See "Locating parts on the system board" on page 104. Then,
locate an available five-wire power connector and connect it to the rear of the new optical drive.
Figure 67. Connecting a SATA optical drive
12. To complete the replacement, go to "Completing the parts replacement" on page 138.

Replacing the hard disk drive

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to replace the hard disk drive.
128
ThinkCentre Hardware Maintenance Manual