Table of Contents
Advertisement
Step 4.
Position the new memory module over the memory connector. Make sure that the notch
memory module aligns correctly with the connector key
module straight down into the connector until the retaining clips close.
Step 5.
Reattach the computer cover.
Replacing a hard disk drive
Note: For this procedure, it helps to lay the computer flat.
To replace a hard disk drive:
Step 1.
Remove the computer cover. Refer to "Removing the computer cover".
Step 2.
Disconnect the data and power cables from the hard disk drive.
Step 3.
Lift up the plastic handle and slide the hard disk drive out of the drive bay.
2
on the system board. Push the memory
1 2
.
Chapter 8
Replacing hardware
1
on the
29
Advertisement
Table of Contents
