HP Xw6600 - Workstation - 2 GB RAM Installation Manual page 5

2. Insert the eSATA adapter into the PCI slot, with the two SATA connector cables protruding inside
the workstation chassis (1), and close the PCI retainer (2) to its locked position (as shown in the
following two figures).
Figure 2
3. Connect the two eSATA adapter cables to SATA ports SATA4 and SATA5 (the two red colored
SATA connectors) on the workstation system board (as shown in the previous and the following
figure).
NOTE:
connect only a single eSATA adapter cable and secure the unused cable so that it does not interfere
with operation of other components within the chassis.
Figure 3
ENWW
Installing the eSATA adapter (HP xw8600 Workstation)
If only one SATA port is available or if you are using only one eSATA device, you can
Connecting the eSATA adapter cables to the system board (HP xw6600 Workstation)
Step 2—Installing the eSATA adapter 5