Installing The Power Supply; Finishing Up - TYAN Tempest i5000VF S5370 User Manual

2.10 - Installing the Power Supply

There are two power connectors on your Tempest i5000VF S5370. The
Tempest i5000VF S5370 requires that you have an EPS12V power supply that
has a 24-pin and an 8-pin power connector. Please be aware that ATX 2.x,
ATX12V and ATXGES power supplies may not be compatible with the board
and can damage the motherboard and/or CPU(s).
Applying power to the board
1. Connect the EPS 12V 8-pin power connector.
2. Connect the EPS 12V 24-pin power connector.
3. Connect power cable to power supply and power outlet
YOU MUST unplug the power supply before plugging the power cables
NOTE
to motherboard connectors.

2.11 - Finishing up

Congratulations on making it this far! You're finished setting up the
hardware aspect of your computer. Before closing up your chassis, make
sure that all cables and wires are connected properly, especially IDE cables
and most importantly, jumpers. You may have difficulty powering on your
system if the motherboard jumpers are not set correctly.
In the rare circumstance that you have experienced difficulty, you can find
help by asking your vendor for assistance. If they are not available for
assistance, please find setup information and documentation online at our
website or by calling your vendor's support line.
29