Super Io Configuration; Onboard Device Configuration; Usb Configuration - TYAN Thunder i7501 Pro S2721-533 Manual

3.6 – Super IO Configuration
Options related to the IO interface can be altered through the following.
Serial Port 1, 2
Address
Parallel Port Address
Parallel Port Mode
Parallel Port
3.7 – Onboard Device Configuration
Options related to onboard devices can be altered through the following.
Onboard ATI RageXL
Video
Onboard 82551
Onboard 82546
Onboard SCSI
3.8– USB Configuration
Options related to USB can be altered through the following.
USB Function
Legacy USB Support
USB Zip Emulation Type
USB Beep Message
Enabled Toggles use of serial ports 1 and or 2. Enabling
Disabled ports also requires you to enter the I/O address for
that port unless you select Auto.
Auto
3F8, 2F8
These options are dependent on the IRQ and vice
3E8, 2E8 versa.
Output Only
Standard one-way protocol for parallel devices.
Bi-directional Two-way protocol
Enhanced Parallel Port may provide higher
EPP bandwidth if an EPP compliant device is used (e.g.
parallel Zip drive).
Enhanced Compatibility Port may provide higher
bandwidth if an ECP compliant device is used (e.g.
ECP
parallel Zip drive).
IRQ
Sets the interrupt request for the parallel port.
IRQ 7
(IRQ 7 and IRQ 5 both can be defaults.)
IRQ 5
Enabled
Toggles the onboard ATI video graphics.
Disabled
Enabled
Toggles 100Mbit LAN port.
Disabled
Enabled
Toggles the 1Gbit LAN ports.
Disabled
Enabled
Toggles the onboard SCSI controller.
Disabled
Enabled
Disabled
Enabled
Disabled
Auto
Enabled
Disabled
Auto
Enabled
Disabled
28
http://www.TYAN.com
Toggles the onboard USB ports.
Toggles the use of onboard USB ports in DOS.
Toggles Zip drive emulation on USB ports
when in use.
Toggles USB beep error messaging.