Table of Contents
Advertisement
3.4 – Floppy Configuration
Options related to floppy drives can be altered through the following.
Floppy A
Floppy B
3.5 – Boot Settings Configuration
Options related to startup settings can be altered through the following.
Quick Boot
Quiet Boot
Add-On Rom
Display Mode
Boot up Num -Lock
PS/2 Mouse
Support
Typematic Rate
System Keyboard
Parity Check
Wait for F1 if "error"
Hit "Del" Message
3.6 – Super IO Configuration
Options related to the IO interface can be altered through the following.
Serial Port 1, 2
Address
Parallel Port Address
Parallel Port Mode
360KB, 5 ¼"
1.2MB, 5 ¼"
720KB, 3 ½"
Defines the floppy drive type.
1.44MB, 3 ½"
2.88MB, 3 ½"
Disabled
Enabled
When set to Enabled, some self-tests will be skipped
Disabled
during POST.
Enabled
If set to Enabled, OEM logo will be displayed instead
Disabled
of POST messages.
Force BIOS
Leave as Default. This setting toggles the Add-On
Keep Current
ROM video display mode.
On
Specifies whether Num-Lock will be on or off during
Off
bootup.
Enabled
Toggles the use of the PS/2 mouse port.
Disabled
Fast
Changes speed of key repeat rate.
Slow
Present
Will allow continual boot even if the keyboard is not
Unavailable
attached.
Enabled
Toggles checking of system memory for corruption.
Disabled
Enabled
If Enabled, you will have to press F1 for the system to
Disabled
continue booting if an error is detected during POST.
Enabled
Toggles display of pressing DEL key to enter BIOS.
Disabled
Enabled
Toggles use of serial ports 1 and or 2. Enabling
Disabled
ports also requires you to enter the I/O address
Disabled
These options are dependent on the IRQ and vice
3F8, 2F8
versa.
3E8, 2E8
Output Only
Standard one-way protocol for parallel devices.
Bi-directional
Two-way protocol
Enhanced Parallel Port may provide higher
EPP
bandwidth if an EPP compliant device is
Enhanced Compatibility Port may provide higher
ECP
bandwidth if an ECP compliant device is used).
http://www.TYAN.com
27
Advertisement
Table of Contents
