TYAN S7002 User Manual page 69

Feature
Configure Remote Access type and parameters
Remote Access
NOTE: The items listed below will appear when Remote Access is set to [Enabled].
Serial Port Number
Base Address, IRQ
Serial Port Mode
Flow Control
Redirection After BIOS
POST
Terminal Type
VT-UTF8 Combo Key
Support
Sredir Memory Display
Delay
Option Description
Enabled
Enables remote access to system
through serial port.
Disabled
Select Serial Port for console
COM1
redirection. Make sure the selected
COM2 port is enabled.
Read only
115200 8,n,1
57600 8,n,1
38400 8, n, 1 Select Serial Port settings.
19200 8,n,1
9600 8,n,1
None
Hardware
Select Flow Control for console
redirection.
Software
Option
Disable: Turns off the redirection after
Disabled
POST
Boot Loader
Boot Loader:
Redirection is active during POST and
during Boot Loader.
Always:
Always
Redirection is always active.
<Some OSs may not work if set to
Always>
ANSI
VT100 Select the target terminal type.
VT-UTF8
Enabled
Enable VT-UTF8 Combination key
Support for ANSI/VT100 terminals.
Disabled
No Delay
Delay 1 Sec
Gives the delay in seconds to display
memory information
Delay 2 Sec
Delay 4 Sec
69
http://www.TYAN.com