Installing I/O Shield - TYAN S7002 User Manual

2.12 - Installing I/O Shield

Before you connect external devices, check your motherboard package and
take out the I/O shield. Follow the instructions below to install the I/O shield to
your rear panel.
Preparation
Flat-head screw driver x 1
Long nose pliers x 1
Protective gloves x 1
I/O shield x 1
Caution
To avoid the risk of personal injury, always wear gloves when handling the I/O
shield. Each optional covered section has a breaking point, which will allow for
the safe removal of the cover. Use the pliers to grasp and twist the covers back
and forth to reach that breaking point and safely remove that section for use.
Installation
Step 1
Use the screw driver to push open the I/O
port cap.
Step 2
Use the pliers to grasp and twist the I/O
port cap off the shield.
Step 3
Repeat Step 1 and 2 as needed to remove
the I/O caps to match your specific SKU's
rear I/O configuration and then attach the
I/O shield to the rear panel.
42
http://www.TYAN.com