Overview Of Components/Terms; Jigs And Push Blocks; Safety Rules - Elektra Beckum PK 300 K Operating Instructions Manual

7

Overview of Components/Terms

1 Riving knife
2 Saw blade guard
3 Rip fence
3a Auxiliary fence
4 Mitre fence
5 Push stick
7.1 Optional Accessories
6 Sliding Carriage
7 Table Rear Extension
8 Table Side extension
Optional accessories not shown:
- Edge Trimming Attachment
- Wheel Set
- Cam-lock Clamp
- Square & Round Stock Jig
8

Jigs and Push Blocks

Make a deflector board when crosscutting small work pieces (see paragraph 11.5
below). Do not use chipboard for making the deflector board.
Always use push stick when cutting strips
of less than 120 mm width (see para. 11.4
below).
9

Safety Rules

As with all power tools there is a certain amount of hazard involved with the operator and his use of the machine. Using the
machine with the respect and caution demanded as far as safety precautions are concerned will considerably lessen the
possibility of personal injury. If, however, normal safety precautions are overlooked or completely ignored, personal injury to
the operator can develop.
2
1
7
6
Always use wedge cutting jig for cutting wedges or tapers (see para. 11.8 below). The
wedge cutting jig should be at least 300 mm long and 170 mm wide.
21
4
3
Make a push block for cutting tenons (see
para. 11.7 below). The recess must corre-
spond to the thickness of the workpiece
that is to be worked.
8
3a
5