Wiring Diagram; Replacing Fuse - Dual AXXERA X2DMA500 Installation & Owner's Manual

BLUE 10-pin Female Mini-DIN
Optional USB Extension Cable
(Included)
FUSE
When replacing the fuse,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The X2DMA500 uses one
10 amp ATM fuse located
beside the wiring connector.
X2DMA500
BLACK Female USB Input
Rear USB Connection
HDM90 Connection (sold separately)
Right Front
Gray/Black (-)
Gray (+)
Left Front
White/Black (-)
White (+)

Wiring Diagram

FRONT
REMOTE IN
Steering Wheel Interface Input
3.5mm Bluetooth Microphone Input
Connect the included
Bluetooth microphone.
BLUE Remote Turn-On
Connect to amplifier or power
antenna. Insulate wire if not used.
BLACK Ground
Connect to the vehicle
chassis ground.
RED Accessory
Connect to an existing ignition
circuit or switched 12 volt source.
YELLOW Memory
Connect to the battery
circuit or constant 12 volt source.
Right Rear
Violet/Black (-)
Violet (+)
Left Rear
Green/Black (-)
Green (+)
3
RCA Preamp Output
Connections
FRONT
REAR
SUBWOOFER
REAR SUB/W
L-CH
R-CH
PAC SWI-PS connection
(sold separately)
Bluetooth Microphone
(must be enabled in the menu after connecting)
Antenna
Connector