Table of Contents
Advertisement
General Operation
Faceplate Removal
Power On/Off
Steering Wheel Interface
Auxiliary Input
Set the Clock
12/24-Hour Clock
Preset Color
Custom Color
XDMA7600
Press RELEASE to fold down the front panel. While pushing the
front panel left, pull the right side away to remove. To reinstall, slide
in bottom left side, then snap left side up and into place.
Press
turn unit off.
Source
Press SOURCE to select between AM/FM, CD, auxiliary input,
operation of iPod, USB, SD and Bluetooth modes. Modes of
operation are indicated in the display.
Note: CD mode will not appear unless a CD is inserted. Operation
of iPod mode will not appear unless an iPod device has been
connected. USB and SD modes will not appear unless a USB device
has been connected or SD card has been inserted.
Note: iPod and iPhone devices may be connected to the front and/
or rear USB ports.
The steering wheel interface input located on the back of the
Input
head unit allows connection to the PAC (Pacific Accessory
Corporation) SWI-PS interface module (sold separately). Visit
www.pac-audio.com for details.
To configure steering wheel controls, follow the instructions
provided with the PAC SWI-PS interface module. After installing
the interface module, insert the module's 3.5mm jack into the port
on the back of the head unit.
Insert 3.5 mm plug to connect your portable audio device.
Volume
Adjust volume using volume knob (00-46).
Mute
Press MUTE to silence the audio.
Press MUTE again to cancel.
Reset
Press the RESET button, located behind the front panel, to reset
the unit back to the factory settings if abnormal operation occurs.
Display
Press DISPLAY to toggle between items such as clock, radio
frequency, or ID3 tag song information.
With the unit on, press and hold DISPLAY until the clock begins
to flash, then release. Press TUNE
ll
TUNE
the selected time.
The clock will display 12-hour AM/PM time in USA frequency
spacing mode (PM 10:00). In European frequency spacing mode,
the clock will display 24-hour time (22:00).
Changing Illuminaton Colors
Press COLOR to enter the color menu. Turn the volume knob to
highlight "PRESET" and press SELECT. Turn the volume knob left/
right to cycle between OFF, AUTO, or 1-31 preset colors.
Press COLOR to enter the color menu. Turn the volume knob to
highlight "CUSTOM" and press SELECT. Choose the level of red from
1-16 using the volume knob. Press SELECT to continue. Choose
the level of green from 1-16 using the volume knob. Press SELECT
to continue. Choose the level of blue from 1-16 using the volume
knob. Press SELECT to confirm the final color.
or any other button to turn unit on. Press and hold
to adjust the minutes. Press DISP momentarily to save
6
nn
to adjust the hours and
to
Advertisement
Table of Contents
