Audio Menu - Dual AXXERA XDMA7600 Installation & Owner's Manual

Audio Menu

Press AUDIO/MENU momentarily to cycle between Bass, Treble, Balance, Fader,
Equalizer, Subwoofer, High Pass Filter and Source Volume Level. Press BACK at any time
to exit the audio menu.
BASS MIDDLE
Balance
Subwoofer
High Pass Filters
Source Volume Level
XDMA7600
TREBLE BALANCE
Bass Press AUDIO/MENU until BASS appears, then rotate the
volume knob left/right to adjust (-6 minimum / +6 maximum).
Middle Press AUDIO/MENU until MIDDLE appears, then rotate the
volume knob left/right to adjust (-6 minimum / +6 maximum).
Treble Press AUDIO/MENU until TREBLE appears, then rotate the
volume knob left/right to adjust (-6 minimum / +6 maximum).
Note: Bass, Middle and Treble settings are retained for each
mode individually.
Press AUDIO/MENU until BALANCE appears, then rotate
the volume knob left/right to adjust (BALANCE LEFT 12 to
BALANCE RIGHT 12). "BALANCE EVEN" represents equal
balance.
Fader Press AUDIO/MENU until FADER appears, then rotate the
volume knob left/right to adjust (FADER FRONT 12 to FADER
REAR 12). "FADER EVEN" represents equal fader.
EQ Press AUDIO/MENU until EQ appears. Rotate the volume
knob left/right to select between FLAT (default), POP, JAZZ,
CLASSIC, BEAT, ROCK and USER equalization curves. Press
SELECT to confirm. Any manual adjustment to the Bass,
Middle or Treble settings are automatically saved as USER.
Press AUDIO/MENU until SUBWFR appears, then press
SELECT to confirm. Rotate the volume knob left/right to
adjust (0-12). Adjusting the level to 0 turns the subwoofer off.
Enabling HPF will filter low subwoofer bass frequencies from
the front/rear speaker outputs. Use this feature to remove
distortion from the speakers
Press AUDIO/MENU until HPF appears, then turn the
volume knob left/right to adjust (62, 95, 135 Hz).
The source volume level control allows a gain adjustment
for each audio source. Set the source volume level for each
mode, depending on the relative volume of each audio source.
To set the source volume level, press AUDIO/MENU until
"SOURCE LEVEL" appears. After one second, the current
mode will appear on the display. Turn the volume knob to
adjust the audio level of the current source (-6 minimum/+6
maximum).
Note: Only the current mode will be available for adjustment.
Change to another mode to set the source level for that
mode.
FADER EQ SUBWOOFER
8
HPF SOURCE LEVEL