Table of Contents
Advertisement
Preparation
Pairing a New Device
Pairing Additional
Most Bluetooth devices support the auto-connect feature, and will connect automatically
if the device is in range when the XDMA7600 is powered-on. If your device was previously
paired but does not connect, use these instructions below.
• If your most recently connected Bluetooth device becomes disconnected or does not
reconnect, press
• To connect a previously paired device that was not recently connected:
1) If applicable, press and hold
2) From Bluetooth mode, press SELECT. "Paired Devices" will appear on the LCD.
3) Turn the volume knob to cycle through the list of devices.
4) Press SELECT or
Note: If the Auto Connect setup menu setting is set to OFF, you must press
connect you device after pairing, and each time the XDMA7600 is powered-on.
Press and hold
paired and appear in the PAIRED DEVICES menu, but not be connected.
XDMA7600
Pairing a Device
Before you can use a Bluetooth device, it must be paired and
connected. Make sure that Bluetooth is activated on your
device before you begin the pairing process.
The XDMA7600 broadcasts the pairing signal constantly
when no devices are currently connected. Complete the
pairing sequence from your Bluetooth device. Refer to the
owner's manual for your device for more details.
The device name is "XDMA7600"
The Bluetooth passcode "1234"
Note: The XDMA7600 can be in any mode of operation
when pairing is performed.
If a device is currently connected, press and hold
Devices
disconnect the current device before a new device can
be paired. Then begin the pairing sequence from the new
Bluetooth device.
Connecting a Paired Device
from Bluetooth mode to reconnect your mobile device.
to disconnect any connected mobile devices.
to connect to the desired device. It must be in range to connect.
Disconnecting a Device
for 3 seconds to disconnect a connected device. The device will remain
Bluetooth
21
Operation
®
to
to
Advertisement
Table of Contents
