Pairing Device; (Re)Connecting Paired Device; Bluetooth Operation; Disconnecting A Device - Dual DCBT304U Installation & Owner's Manual

Preparation
Pairing a New Device
Pairing Additional Devices
Most Bluetooth devices support the auto-connect feature, and will connect automatically
if the device is in range when the DCBT304U is powered-on. If your device was previously
paired but does not connect, use these instructions below. Some devices require
authorization to allow the auto connect feature.
• If your most recently connected Bluetooth device becomes disconnected or does not
reconnect, press
• To connect a previously paired device that was not recently connected:
1) If applicable, press and hold
2) From Bluetooth mode, press SELECT. "Paired Devices" will appear on the LCD.
3) Turn the volume knob to cycle through the list of devices.
4) Press SELECT or
Note: If the Auto Connect setup menu setting is set to OFF, you must press
you device after pairing, and each time the DCBT304U is powered-on.
Press and hold
paired and appear in the PAIRED DEVICES menu, but not be connected.
Before you can use a Bluetooth device, it must be paired and
connected. Make sure that Bluetooth is activated on your
device before you begin the pairing process.
The DCBT304U broadcasts the pairing signal constantly
when no devices are currently connected. Complete the
pairing sequence from your Bluetooth device. Refer to the
owner's manual for your device for more details.
The device name is "DUAL BT"
The Bluetooth passcode "1234"
Note: The DCBT304U can be in any mode of operation when
pairing is performed.
If a device is currently connected, press and hold
disconnect the current device before a new device can be
paired. Then begin the pairing sequence from the new
Bluetooth device.
from Bluetooth mode to reconnect your mobile device.
to disconnect any connected mobile devices.
to connect to the desired device. It must be in range to connect.
for 3 seconds to disconnect a connected device. The device will remain
DCBT304U OPERATION
Bluetooth
(Re)Connecting a Paired Device
Disconnecting a Device
Operation
®
Pairing a Device
to connect
to
15