Information; Setup - Runco VideoXtreme VX-3000 Operation Manual

Select Information from the Main Menu to see projector status information: the
currently-active source, input signal resolution, aspect ratio, picture memory and lamp
usage. This menu also displays the projector serial number.
Should you ever need to contact Runco Technical Support, this information will help them
answer your questions or resolve product performance issues.
You can also press INFO on the VX-3000 remote control unit (Figure
Tip
2-4) to display this information.
To access advanced projector settings, use the up- or down-arrow keys to highlight
Setup and press ENTER. Use the number buttons on the remote to enter the Setup
menu passcode when prompted and press ENTER again. Then, press MENU on the
remote control.
You only need to enter the Setup menu passcode the first time you
Note
select that menu after turning on the projector.
Lamp Power: Select Lamp Power from the Setup Menu to adjust the lamp output level.
You can choose to run the lamp as bright as possible (200W; this is the default setting) or
you can choose the lower (170W) setting. Generally, lower lamp output prolongs the life of
the lamp, but decreases brightness.
Lamp Hours: When you replace the projector lamp (refer to Lamp Replacement on
page 73), you should also reset the lamp timer. To do this, select Lamp Hours from the
Setup menu. Press the right-arrow key on the remote to highlight "Yes," then press
ENTER to confirm the reset.
Reset the Lamp Timer ONLY after you replace the lamp. Otherwise,
Note
the reported "Lamp Hours" will be inaccurate.
Do not exceed the recommended lamp life of 2000 hours. An old
WARNING
lamp becomes increasingly fragile and prone to sudden failure.
Fan Mode: Select Fan Mode from the Setup Menu to control the operation of the
projector's cooling fan.
In most cases, the default Fan Mode (Normal) will maintain the correct operating
temperature. If the lamp frequently turns off due to overheating, or in certain high-altitude
operating environments, you may need to change this setting to Hi. Altitude or Manual.
To manually set the fan speed, select Manual and press ENTER. Then, use the on-screen
slidebar to adjust the speed.
Background Color: Press the
(black, blue or gray). The Background Color appears when no incoming signal is present.
PIP: To enable or disable the picture-in-picture (PIP) feature, highlight PIP in the Setup
menu and press or
VX-3000 Installation/Operation Manual
or button to select the image Background Color
to select On or Off.
67
Operation

Information

Information
Source HDMI 1
Resolution 1920x1080
Aspect Ratio
Picture Memory ISF Night
Lamp Hours
Serial RUP900RS0805001
pÉíìé

Setup

Lamp Power 200 Watts
Lamp Hours
Fan Mode Normal
Background Color Black
PIP
RVR
12-volt Trigger Normal
V. Correction
Amplitude
Auto Off
Default
16:9
450
>
Off
0
0
>
0