Runco VideoXtreme VX-3000 Operation Manual page 60

Installation
5. Use the Height/Y Adjustment T-Screws/Washers (item #3), Pitch Adjustment
T-Screws/Washers (item #4) and T-Nuts (item #9) to attach the Pitch Adjustment
Yoke and Lens Adapter Ring to the Anamorphic Lens Holder. The Yoke should be
as close to the primary lens as possible.
6. Attach the lens to the Lens Adapter Ring by threading it clockwise.
Lens threads into ring
Figure 3-21. Attaching the Anamorphic Lens to the Lens Ring
Configure Lens Motor Trigger: CineWide with AutoScope maintains constant image
height independent of the aspect ratio, while using the full display resolution of the
projector. It accomplishes this by moving the anamorphic lens in front of the primary lens
when widescreen material is being viewed. When the viewer transitions back to 16:9 or
4:3 source material, the anamorphic lens moves out of the light path.
To configure the lens motor trigger on the VX-3000 for proper AutoScope operation:
1. Press MENU on the remote control.
2. Select Setup from the Main menu and press ENTER.
3. Use the number buttons on the remote to enter the Setup menu passcode when
prompted and press ENTER again. Then, press MENU on the remote control.
4. Select 12-volt Trigger from the Setup menu.
5. Set the 12-volt Trigger to "Cinema." This enables the lens motor to move the
anamorphic lens into position (in front of the primary lens) when the Cinema or Virtual
Cinema aspect ratio is selected.
46 VX-3000 Installation/Operation Manual