Runco VideoXtreme VX-3000 Operation Manual page 37

5. Remove the rear cap from the lens.
This protective cap is only used during
shipping to protect the lens from
damage.
6. Carefully cut and remove the plastic band
around the lens motor connector wires.
Take great care not to cut the wires!
7. Detach the lens motor connector from the
motor by removing the two screws holding it
in place.
8. Note that the lens mount flange has a female
socket connector for the lens motor on the
right side of the flange.
VX-3000 Installation/Operation Manual
REMOVE
REMOVE
Lens Motor
Connector
23
Installation