Remote Start Shutdown Diagnostics - Directed Electronics READY REMOTE 24923 Installation Manual

Remote start shutdown diagnostics

If the remote start activates but fails to stay running, the remote start module has the ability to inform you of
what may have caused the remote start failure. Before performing shutdown diagnostics it is important that
you let the remote start shut off on its own i.e. let it attempt to start 3 times then shut down, if this is not done
the unit will report the shutdown you used to shut off the remote start.
Note: Shutdown diagnostics does not report if the vehicles factory immobilizer is causing the problem.
To perform shutdown diagnostics:
1. With the ignition Off, press and hold the Control (Valet switch) button
2. Turn the ignition On and then back Off while holding the Control button.
3. Release the Control button.
4. Press and release the Control button. The LED flashes to report the last shutdown for one minute or until
the ignition is turned on, as shown in the following table:
LED Flashes
1 flash
2 flashes
3 flashes
4 flashes
5 flashes
6 flashes
7 flashes
8 flashes
26
Shutdown Mode
Runtime expired
Over-rev shutdown
Low or no RPM, low battery (voltage and virtual tach modes)
Transmitter shutdown
(-) Hood shutdown (H3/4 GRAY)
(+) Brake Shutdown (H3/3 BROWN)
Neutral safety shutdown (H3/1BLACK/WHITE)
Wait-to-start timed out
© 2010 Directed Electronics. All rights reserved.