Directed Electronics READY REMOTE 24923 Installation Manual page 19

Caution! If these wires are not connected properly, (+) 12 volts will be
sent directly to (-) ground, possibly damaging the
switch.
Type D: Adding one or more aftermarket actuators
In order for this system to control one or more aftermarket actuators, a DEI 451M (not included) or two relays
are required. Vehicles without factory power door locks require the installation of one actuator per door. This
requires mounting the door lock actuator inside the door.
Other vehicles may only require one actuator installed in the driver's door, if all door locks are operated when
the driver's lock is used. This type of installation is required to operate factory lock systems in Volvo (except
850), SAAB, and most Kia, Mazda, Isuzu and Subaru models. The fuse used on 12 volt inputs should be
7.5A per motor installed in the vehicle.
Important: Do not connect
Important:
stores.
© 2010 Directed Electronics. All rights reserved.
alarm outputs directly to the actuator.
Directed offers actuators available at larger retail chain
alarm or the factory
19