Programming System Features - Directed Electronics READY REMOTE 24923 Installation Manual

Programming system features

The System Features Learn Routine dictates how the unit operates. It is possible to access and change most of
the feature settings (see Feature Menus) using the Control (Valet Switch) button.
1. Turn the ignition on, then off.
2. Select a Menu. Press and hold the Control button. The number of LED flashes (on the control module)
and horn honks* indicates the menu number. A single LED flash and honk indicates menu 1. Two LED
flashes and 2 honks indicates menu 2.
3. When the desired menu LED flashes and honks occur, release the Control button.
4. Select a Feature. Press and release the Control button the number of times corresponding to the
feature you wish to change. Then press and hold one more time to select the feature. The LED flashes
and the horn honks to indicate which feature is selected.
5. Program the Feature. While holding the Control button, you can program the feature using the remote
control.
For features with only two options;
For features with more than two options;
horn honks indicating which option is selected.
* Horn function is a programmable feature, it is Off by default. See
turn on.
Once a feature is programmed:
• Other features can be programmed within the same menu
• Another menu can be selected
• The learn routine can be exited if programming is complete
To access another feature in the same menu:
1. Press and release the Control button the number of times necessary to advance from the feature you just
programmed to the next one you want to program.
2. Then press the Control button once more and hold it.
To select another menu:
1. Press and hold the Control button.
2. After 3 seconds, the unit advances to the next menu, the horn honks and the LED flashes indicating which
menu has been accessed.
The learn routine exits if any of the following occurs:
• The ignition is turned On
• There is no activity for 30 seconds
• The Control button is pressed too many times
© 2010 Directed Electronics. All rights reserved.
= option 1 while = option 2.
selects the options in ascending order. The LED flashes and the
and use this procedure to
Feature Menus
27