Table of Contents
Advertisement
the doors with just one push of the transmitter's Lock button. If you
push transmitter's Lock button again within 3 seconds -- you will lock
AND start the vehicle.
SETTING PROGRAM OPTIONS:
If you want the factory setting, DO NOTHING and skip this section. If you
want to change to one of the options, TURN THE ON/OFF
CONTROL SWITCH TO THE "OFF" POSITION. Wait for the red LED to
stop flashing, then continue with the following procedures:
A. Push the white button to the left of the red LED. Each time you
push the white button the red LED will flash 1 to 8 times signifying
at which option you are (press it once, the LED flashes once. Press
it again and it will flash two times. Press it again and it will flash
three times, etc., to show what option you are at).
B. When you are at the option level you desire, push the red button for
a second and the red LED will flash once for Option setting and
Twice for Factory setting.
C. You can choose the next option by pushing the left button again to
index to the next option. When you get to the next option you want
to change, simply repeat Step B above. After six seconds, the
AutoCommand
LED flashes).
D. Turn the Control Switch back ON and confirm that the LED flashes
once as the switch is turned ON.
SPECIAL CASES
1) VATS system (for GM cars with special PASS key).
If you have a GM vehicle with a factory anti-theft system (a resistor in the key),
you need to follow these directions:
Measure the resistance of the key. It should be between 392 ohms and 11,800
ohms. To do this, put the ohm meter probes on each side of the key pellet. This
value should be close to one of the following (all values in ohms): 392, 523,
681, 887, 1.13K, 1.47K, 1.87K, 3.01K, 3.74K, 4.75K, 6.04K, 7.5K, 9.53K,
11.8K. Purchase a resistor with a value within 5% of this measured value and
a 30 amp BOSCH type relay.
Locate the pair of VATS wires (sometimes White/Black striped and Purple/
Black striped) running behind the dash from the passenger side to the driver's
© 2005 Directed Electronics, Inc.
automatically exits the programming mode (Three
®
15
Advertisement
Table of Contents
