Advertisement
Mounting on Top of a Post
In order to mount the Radiation Shield onto the top of a post, you will need the
Radiation Shield assembly (with mounting bracket already attached). You will
need to supply four 1/4" x 1 1/2" lag screws.
To mount the Radiation Shield, simply use the four 1/4" x 1 1/2" lag screws
(not included), to attach the mounting bracket to the mounting surface in the
desired location.
M
AINTENANCE
The effectiveness of the Radiation Shield will be reduced if the surfaces of the
shield become dirty.
Wipe the surfaces of the shield using a damp cloth to remove dirt etc.
Keep areas between Radiation Shield plates free of debris that may obstruct air
flow e.g., leaves, twigs, webs, nests.
DO NOT remove nesting insects or animals by spraying insect killer of
any kind into the radiation shield because this may damage the sensors
and the Radiation Shield.
Maintenance Instructions
A
M
TTACHING
OUNTING
I
NSTRUCTIONS
B
T
RACKET TO THE
OP OF A
P
OST
Page 15
Advertisement
