Advertisement
M
OUNTING THE
Follow the instructions below to mount the Radiation Shield. There are sepa-
rate sections for each of the basic mounting options. You should modify the
instructions as necessary to fit your needs.
Mounting On the Side of a Post or Wall
In order to mount the Radiation Shield onto the side of a post or wall, you will
need the Radiation Shield assembly, three #8 split lock washers, three #8 flat
washers, and three #8 hex nuts. You will also need to supply four 1/4" x 1 1/2"
lag screws.
1. Using four 1/4" x 1 1/2" lag screws (not included), attach the mounting bracket to the
mounting surface in the desired location.
2. Slide the stud ends protruding from the top of the Radiation Shield assembly into the
holes on the mounting bracket.
3. Secure the mounting bracket to the Radiation Shield using a #8 flat washer, #8 split
lock washer and #8 hex nut one each of the stud ends.
Tighten until the mounting bracket is firmly attached to the Radiation Shield
#8 Hex Nut
#8 Lock Washer
#8 Flat Washer
Page 12
R
ADIATION
A
M
B
TTACHING
OUNTING
A
R
S
TTACHING
ADIATION
S
HIELD
S
RACKET TO THE
IDE OF A
Complete Plate
Assembly
M
B
HIELD TO
OUNTING
RACKET
P
OST
Radiation Shield Manual
Advertisement
