2. This device must accept any interfer- Channel selection ence, including interference that may cause undesired operation. Sub-Channel (CTCSS) Zone selection Thank you for your purchase of this Dakota Alert product. Technical support MURS Frequencies The MURS Alert transmitter is a passive infrared (PIR) Address...
Instructions: When you open the MURS exterior case MURS Alert Transmitter Antenna (fi gure 1- ), you will see an antenna (fi gure 1- ), a battery pack and the fi gure 1 PIR unit. Attach the antenna to the antenna jack (fi...
Installation: In order for the sensor to detect properly it is recommended that the transmitter be mounted on a tree or post about 20 feet back from the area to be monitored and about 3 to 4 feet off the ground. If you want to detect smaller animals, the sensor can be mounted closer to the ground.
fi gure 3 fi gure 4 4. PIR sensor 5. Retention clips 6. Channel switch 7. Sub-channel switch 8. Alert zone message switch Locating the radio transmitter: When looking at the PIR (fi gure 3) you will see clips on the sides of the plastic case. Push one of the clips away from the center of the case and lift out the PIR and the plastic back- ing.
slide switch. If the switch is all the way to the top, it will be zone one, the other zones will be located in order from the top. Operation: A. The factory-set default for the transmitter is Channel 01 Sub-channel (CTCSS) 01. B.
Frequency Chart Sub Code (CTCSS) Frequency Channel Channel Frequency Power Code Frequency Code Frequency Code Frequency (Hz) (Hz) (Hz) Type (MHz) (Watts) 103.5 162.2 MURS 151.820 67.0 107.2 173.8 MURS 151.880 71.9 110.9 179.9 MURS 151.940 74.4 114.8 186.2 MURS 154.570 77.0 118.8...
WARRANTY Dakota Alert warrants this product to be free of defects in material and workmanship for a period of one year from the date of purchase. This warranty does not cover damage resulting from accident, abuse, act of God or improper operation.