Related Manuals for Dakota Alert DCMT-4000
Summary of Contents for Dakota Alert DCMT-4000
- Page 1 Dakota Alert ® WIRELESS SECURITY EQUIPMENT Wireless Motion Detector Transmitter DCMT-4000 USER GUIDE www.dakotaalert.com...
-
Page 3: Package Contents
This DCMT-4000 Dakota Alert Motion Detector transmits a signal to your DCR-4000 receiver when it detects a person or vehicle in the monitored area. Connect multiple motion detectors (or other transmitters) to your receiver to create a complete security system. - Page 4 ADJUSTING MOTION DETECTOR SETTINGS To adjust your settings, move the jumpers inside the motion detector’s case to complete a circuit. 1. Remove the four screws on the back of the motion detector and remove the cover. Back 2. If the battery is connected, remove it from the motion detector. Inside...
- Page 5 3. Gently pull off the jumper for the setting you want to change. Note: If you can’t remove the jumper with your fingers, you can use tweezers. Jumper Jumper pin 4. Gently slide the jumper back onto the pair of jumper pins that corresponds with the setting you want.
- Page 6 LED: Turns LEDs on or off. • LED lights for 2 seconds when motion is detected. Filter: Changes the sensitivity level of the motion detector to filter out small movements like • leaves moving outside. OFF: for indoor use for outdoor use Reset: Changes the minimum time between alarm activations.
-
Page 7: Installing The Battery
INSTALLING THE BATTERY 1. Remove the four screws on the back of the motion detector and remove the cover. 2. Connect a 9V alkaline battery (not included) to the motion detector and place it in the battery slot. 3. Replace the cover and secure with the screws. CONNECTING TO YOUR RECEIVER Note: You can connect up to 16 transmitters to your receiver. - Page 8 5. If you are coding more than one transmitter, repeat steps 3 and 4. 6. After your transmitter(s) are coded, press and hold the MODE button until the LEDs stop flashing. 7. To test the tune, activate the motion detector. You’ll hear the selected tune through your receiver and the lights will flash.
- Page 9 3. Use a drill and the included screws to mount the bracket. Make sure that the arrow on the bracket is facing up. Swivel mount Plate mount 4. Slide the transmitter down onto the bracket. The LED on the transmitter should be toward the top of the case to work properly.
-
Page 10: Adjusting The Volume
WARRANTY Dakota Alert warrants this product to be free of defects in materials and workmanship for a period of one year from the date of purchase. This warranty does not cover damage resulting from accident, abuse, act of God, or improper operation. -
Page 11: Legal Notices
LEGAL NOTICES This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. - Page 12 Dakota Alert ® WIRELESS SECURITY EQUIPMENT Dakota Alert, Inc. www.dakotaalert.com Phone: (605) 356-2772 Fax: (605) 356-3662 Address: 32556 477th Ave. | P0 Box 130 | Elk Point, SD 57025 18-0640...