Fostex VF16 Supplement Owner's Manual page 5

Addition of Channel SOLO function
In the VF-16 with the previous software version, if
you would like to monitor only a certain channel,
all the other channels faders must be turned down.
With the V3.1 software, one key manipulation allows
to turn on and off of the SOLO on a desired channel.
• Turning on and off of channel SOLO function
Pressing a desired [CH STATUS/CH SEL] key with
holding down the [SHIFT] key will SOLO the
corresponding channel and the [CH STATUS/CH SEL]
key will start flashing.
If you do the same key manipulation as above again,
the SOLO function will be canceled.
Tips:
• Turning ON the SOLO function on a muted
channel allows to listen to the signal routed to
the corresponding channel. If the SOLO function
is canceled, the signal is muted again.
• In the Normal Display condition, when the SOLO
function on one of the channels is ON, pressing
the [CH STATUS/CH SEL] key on a channel on
which the SOLO function is set to OFF will cancel
SOLO function on all the channels.
• In the Normal Display condition, the channel on
which the SOLO function is turned ON will
automatically become a CH PARAM EDIT objective
channel. For example, when entering the EQ Edit
mode after the Channel 2 SOLO function is turned
ON, Channel 2 will be automatically in a condition
that the EQ parameters can be edited.
• When in BUSS REC mode, turning ON/OFF of the
SOLO function on the SOURCE channel will
automatically turn ON/OFF of READY channel.
(Turning ON/OFF of READY channel cannot be
manually controlled.)
VF-16 Owner's Manual V3.1 Supplement
Expanded LOCATE Function
The following LOCATE functions have been expanded
on the V3.1 software.
• Expanded on ABS LOCATE Function
Pressing the [RECORD] key with holding down the
[STOP] key allows to locate to the start time of the
last recording promptly.
< CAUTION >
If no recording is executed after powering on, the above
key manipulation will locate to " ABS 0 ".
• Expanded on SEEK LOCATE Function
The SEEK LOCATE function can be executed by
pressing either the [F FWD/NEXT] or [REWIND/PREV]
key with holding down the [SHIFT] key and locates
to the next or previous Event Memory point. On the
V3.1 software, the SEEK LOCATE function has been
expanded. The number of times that the [F FWD/
NEXT] or [REWIND/PREV] key is pressed is memorized
and locate to the further corresponding Event
Memory point.
< Example >
In order to locate to the event memory point EVT05
which is the 2nd event memory point ahead from the
current position, press the [F FWD/NEXT] key twice with
holding down the [SHIFT] key.
EVT 01 EVT 02
ABS0 02M30S 05M00S
• DIRECT LOCATE on Event Map Display
While in the condition that the Event Map is
displayed (pressing the [SCENE-STORE/MAP] key with
holding down the [SHIFT] key), designating a desired
event memory and locating is possible.
< Example >
In the below Event Map Display, selecting the Event
Memory 02 (00h 00m 00s 00sf) by rotating the [JOG]
dial and then pressing the [LOCATE] key will allow to
locate to 00h 05m 00s 00sf and automatically go back
to the Normal Display condition.
5
Current position
10M00S
EVT 03 EVT 04 EVT 05
07M30S 12M30S 15M00S
[SHIFT] key + [F FWD/NEXT] key
EVT 06
17M30S