Procedure For Changing Parameters In Settings 1 - Electrolux FOM 71 CLS Maintenance Manual

Adjustment of temperature, speed and water
7:2
NOTE: It is advisable that authorized technicians from Electrolux
Laundry Systems are contacted before any change is made.

Procedure for changing parameters in SETTINGS 1

Electrical installation must be carried out by an authorized personnel
• Turn main switch at the rear of the machine to OFF.
• Disconnect the machine from the main power.
• Unscrew the lid to the rear electrical connection box (4 screws) and re-
move the lid.
• Remove the main switch knob from the lid and place the knob in the
main switch again.
• Reconnect the machine to main power and turn the main power switch
to ON.
• Select MENU in display.
• Go down to SETTINGS 1.
• Select and change the desired parameter. For a list of available parame-
ters, see Table 1.
• Once all changes have been made, go to READY (last line in Settings 1).
• Insert a short-circuit jumper over the two pins to the right in connection
X80 on the A21 board in rear connection box. (The board to the right
facing rear). The location of X80 is shown in fig. 1. The jumper is stored
on one of the pins in the X80 connector.
• Press SELECT on the front panel and read in display that the changes
have been loaded into the CPU.
• Disconnect the jumper. Replace the jumper on only one pin.
• Turn main switch to OFF and disconnect main power.
• Re-fit the main switch knob in the rear connection box lid and re-fit the
lid on the machine (knob in the OFF position).
• Connect the machine to main power and turn main switch to the ON
position.