Instructions - Nautilus NS-4000 Assembly Instructions Manual

Step #1 Instructions:
A. Set the Main Base (1) in a position close to the gym's final
position.
B. Attach Pec Fly Support and Press Arm Support Uprights
(2)(3) to the Main Base (1) using the hardware shown. Do
not tighten hardware.
C. Attach the Main Top Frame (4) to the Uprights (2)(3) using
the hardware shown. Tighten all hardware in instructions B
and
C securely.
D. Removing the bracket and rubber ball from the end of one
side of the Low Row Cable (95), route the Cable as shown.
The Cable should route through the Seat Row Frame (9),
the Pec Fly Base (6), and under the two assembled Pulleys
in the Main Base (1). Re-install the ball and bracket to the
end of the Cable and set the excess cable aside as shown.
E. Attach the Pec Fly Base (6) to the Main Base (1) and the
Seat Row Frame (9) to the Pec Fly Base (6) using the
hardware shown. Do not tighten hardware.
F. Attach the Pec Fly Top Beam (8) to the Main Top Frame (4)
using the hardware shown. Do not tighten hardware.
G. Attach the Pec Fly Main Frame (5) to the Pec Fly Base (6)
and the Pec Fly Top Beam (8) using the hardware shown.
Tighten all hardware in instructions E, F, and G securely.
H. Attach the Pec Fly Mount (11) to the Pec Fly Main Frame (5)
using the Backing Plate (15) and the hardware shown.
Tighten hardware securely.
I. Attach the Right Pec Fly Handle (14) to the Pec Fly Mount
(11) using the hardware shown. Tighten hardware securely
making sure that the Pec Fly arm can rotate freely.
J. Place the Pec Fly Range of Motion (12) on the Left Pec Fly
Handle (13) as shown and attach the Left Pec Fly Handle
(13) to the Pec Fly Mount (11). Tighten hardware securely
making sure that the Pec Fly arm can rotate freely.
K. Install the Plastic Cap (83) in the two locations shown. It
should snap into place locking around the Shim Washer
(136).
L. Slide a Plastic Washer (82), Pec Fly Roller Pad (80), another
Plastic Washer (82), and a Roller Collar (16) onto each Pec
Fly Handle (13)(14) as Shown. Lock the Collar in place by
securing the Set Screws (142) as shown.
M. Attach the Pec Fly Seat Pad (74) to the Pec Fly Seat
Adjuster (10) and slide the seat adjuster tube in the Seat
Row Frame (9) as shown. Tighten hardware securely.
N. Attach the Pec Fly Back Pad (73) to the Pec Fly Back
Adjuster (7) and slide the back adjuster tube into the Pec
Fly Main Frame (5) as shown. Tighten hardware securely.
O. Install the T Handle Pop Pin (91) in the
Pec Fly Main Frame (5) using an
adjustable wrench.
NS-4000
7