TIP
HP Kayak XW Series 0480 PC Workstation — HP VISUALIZE fx6 Texture Module
Installing the Texture Module
Replacing the VISUALIZE fx6 Graphics Board
1 First ensure that the system board data cables are correctly routed
and flat against the system board so that they do not obstruct the
VISUALIZE fx6 graphics board.
2 Hold the board with both hands and carefully slide it down toward
the accessory slots' connectors.
When sliding the board down, ensure that the board does not snag or
catch against the PC Workstation's case.
3 Align the board's two connectors with the two accessory slot
connectors and push the board firmly into the position.
4 Ensure that the board's connectors are fully connected before
securing it with the two accessory slot screws, and the retaining
screw the holds the board in place (refer to the graphic on page 5 to
locate these screws).
5 Replace the PC Workstation's cover. Reconnect all cables and power
cords.
8