Zanussi ZCV560M User Manual page 12

• Clean the front of the appliance with a soft cloth with
warm water and cleaning agent.
• To clean metal surfaces use a usual cleaning agent
• Clean the oven interior after each use. Thus you can re-
move dirt more easily and it does not burn on.
• Clean stubborn dirt with a special oven cleaner.
• Clean all oven accessories (with a soft cloth with warm
water and cleaning agent) after each use and let them
dry.
• If you have nonstick accessories, do not clean them
using an aggressive agents, sharp edged objects or
dishwasher. It can destroy nonstick coating!
Cleaning the oven door
The oven door has two panels of glass installed one be-
hind the other. To make the cleaning easier remove the
oven door and the internal panel of glass.
Warning! The oven door can close if you try to
remove the internal panel of glass when the door is
still assembled.
Warning! Make sure that the glass panels are cool,
before you clean the glass door. There is risk that
the glass breaks.
Warning! When the door glass panels are damaged
or have scratches, the glass becomes weak and can
break. To prevent this you must replace them. For more
instructions, contact your local Service Centre.
Removing the oven door and the glass panel
1
Open the door fully
and hold the two door
hinges.
12
2
Lift and turn the levers
on the two hinges.
3
Close the oven door to
the first opening position
(halfway). Then pull for-
ward and remove it from
its seat.
3
2
2
5
Use a spatula made of
wood or plastic or equiva-
lent to open the inner door
Hold the outer door, and
push the inner door
against the top edge of the
door
Warning! Only clean the glass panel with water and
a soap. Abrasive cleaning agents, stain removers
and sharp objects (e.g. knives or scrapers) can cause
damage to the glass.
Inserting the door and the glass panel
When the cleaning procedure is completed, insert the
oven door. To do so, do the steps in opposite way.
1
1
4
Place the door on a
stable surface protected by
a soft cloth.
Use a screwdriver to re-
move 2 screws from bot-
tom edge of door
Important! Do not loose
the screws
6
Lift the inner door
7
Clean inner side of the
door
Clean the glass panel with
water and soap. Dry it
carefully.