Canon FAX-JX300 User Manual page 79

TAM MEMORY FULL*
Cause
Either 55 messages, including an
outgoing message, alternative
message, voice memos, Fax/Tel
message and forwarding message,
have been recorded or the total
maximum recording time of 30 minutes
has been reached.
* FAX-JX500/JX300 only.
TX/RX CANCELLED
Cause
You pressed [Stop] to cancel the
transmission.
TX/RX NO. nnnn
Cause
When the fax sends or receives a
document, it assigns it a unique
identification number (nnnn).
!!CHECK!! nnnn
Cause
An error requiring servicing might have
occurred.
Listen to your telephone messages and delete any unnecessary messages.
Alternatively, erase all telephone messages stored in the fax memory (see
page 41).
If required, try sending again.
Write the number down if you will need it later.
Turn OFF the machine, and unplug the power cord of the machine from the
power supply. After a while, plug the power cord of the machine back in and turn
ON the machine. If the same error occurs, contact a Canon service
representative.
Action
Action
Action
Action
Troubleshooting 77