Adjusting The Upper Thread Trimming; Adjusting The Installation Height Of The Upper Thread Scissors - Brother HE-800A User Manual

10. STANDARD ADJUSTMENTS

- . Adjusting the upper thread trimming

Center of the needle

- - . Adjusting the installation height of the upper thread scissors

3982Q
Loosen the screw (1), and then move the upper thread scissors (2) up or down to adjust the clearance between the
upper thread scissors (2) and the work clamp (3) to approximately 1 mm.
Note:
The work clamp (3) will tilt when sewing joints, so adjust so that the upper thread scissors (2) do not touch it. If the
upper thread scissors (2) touch the work clamp (3), the work clamp lifter pulse motor may get out of step.
* If the tilting of the work clamp (3) causes skipped stitches to occur when sewing material joints, use the accessory
auxiliary sheet (4) as shown in the illustration.
75
The standard distance (A) between the upper thread
scissors (1) and the center of the needle is 5.5 to 6.0 mm
when the work clamp is lowered by pressing the RESET
key after setting the machine to the home position.
4103M
HE-800A
3983Q