If The Thread Breaks During Sewing - Brother HE-800A User Manual

- . If the thread breaks during sewing

When the thread breakage detector operates, the sewing machine will stop and "E-01" will appear in the parameter
display LED (1).
Re-thread the thread.
To finish sewing in this condition [Next sewing]
1. Press the RESET key (2). The needle zigzag and feed mechanisms will return to the sewing start position, and the
work clamp will rise.
2. Sewing will start again when the treadle is depressed.
To start sewing again from slightly before or after the thread breakage [Resuming sewing]
1. Press the parameter UP key (3) to move the zigzag and feed mechanisms to the next sewing position.
Press the parameter DOWN key (4) to move the zigzag and feed mechanisms to the previous sewing position.
* The "E-01" display will be cleared at this time.
2. Move to the position to continue sewing from, and then depress the treadle. The rest of the sewing will be carried
out.
To sew from the sewing start point without raising the work clamp (without shifting the material)
[Re-sewing]
1. While pressing the parameter DOWN key (4), press the RESET key (2).
* The needle zigzag and feed mechanisms will return to the sewing start position, but the work clamp will not rise.
2. Depress the treadle to start sewing.
* If the thread breakage detector operates during sewing, the needle will move to the right before the sewing machine
stops, in order to make threading easier.
An alarm will sound while the error is being displayed, but if circuit board DIP switch 1 - No. 7 is set to ON,
you can set the alarm to sound only three times. (Refer to "13. CHANGING FUNCTIONS USING THE DIP
SWITCHES".)
HE-800A
8. SEWING
3965Q
66