Completing The Installation - IBM HS21 - BladeCenter - 8853 User Manual

7. Orient the expansion unit as shown in the illustration.
8. Lower the expansion unit so that the slots at the rear slide down onto the cover
9. Close the expansion unit (see the documentation for the expansion unit for
If you have other expansion units to install, do so now; otherwise, go to "Completing
the installation."

Completing the installation

To complete the installation, complete the following tasks. Instructions for each task
are in the following sections.
1. Reinstall the blade server bezel assembly, if you removed it (see "Installing the
2. Reinstall the Memory and I/O Expansion Blade, if you removed it to install other
3. Close the blade server cover, unless you installed an optional expansion unit
4. Reinstall the blade server into the BladeCenter unit (see "Installing the blade
5. Turn on the blade server (see "Turning on the blade server" on page 11).
6. For certain options, run the blade server Configuration/Setup Utility program
34
BladeCenter HS21 Type 8853: Installation and User's Guide
pins at the rear of the blade server.
information and instructions):
a. If the expansion unit has an extraction device, pivot the expansion unit
closed; then, use the extraction device to fully seat the expansion unit on
the system board. These extraction devices can be of several types,
including thumbscrews or levers.
b. If the expansion unit has no extraction device, pivot the expansion unit
closed; then, press the expansion unit firmly into place until the blade-cover
releases click.
The connectors on the expansion unit automatically align with and connect to
the connectors on the system board.
blade server bezel assembly" on page 35 for information on installing the bezel
assembly).
options (see "Installing an expansion unit" on page 33 for information on
installing the Memory and I/O Expansion Blade).
that has its own cover (see "Closing the blade server cover" on page 35).
Statement 21:
CAUTION:
Hazardous energy is present when the blade server is connected to the
power source. Always replace the blade cover before installing the blade
server.
server in a BladeCenter unit" on page 36).
(see Chapter 4, "Configuring the blade server," on page 39).
Note: If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade
server flashes slowly before you press the power-control button.