Installing An Adapter - IBM 8840 - eServer xSeries 346 Installation Manual

v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when handling devices during cold weather. Heating reduces

Installing an adapter

The following notes describe the types of adapters that the server supports and
other information that you must consider when installing adapters:
v PCI-X slots 1 and 2 support non-hot-plug, 64-bit, 100 MHz, low-profile adapters.
v PCI-X slots 3 and 4 support non-hot-plug, 64-bit, 133 MHz, standard full-length
v The optional IBM Remote Supervisor Adapter II SlimLine can be installed only in
metal part of the server for at least 2 seconds. This drains static electricity from
the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on the server cover or on a
metal surface.
indoor humidity and increases static electricity.
adapters.
a dedicated slot on the system board. The following illustration shows how to
install the Remote Supervisor Adapter II SlimLine.
Retainer bracket
Slip the free end of the card under the tab on the retainer bracket; then, press
the card in the connector and make sure that all tabs on the latch bracket secure
the card in place.
Remote Supervisor
Adapter II SlimLine
Latch bracket
Connector
Chapter 2. Installing options
9