Connection To The Drainage System - Miele W 163 Operating Instructions Manual

Connection to the drainage
system
The machine drains via a drain pump
with a delivery head of 1 metre. The 1.5
metre long drain hose must not be
kinked as this would restrict drainage.
The swivel elbow at the end of the hose
can be turned in either direction, or can
be detached if required, with a sharp
twist and pull.
Drain hose connection:
1. Direct into a sink.
– Hook the hose over the edge and
secure.
– Make sure that the water can drain
away freely without hindrance.
Otherwise there is a risk of water
overflowing or of some of the drained
water being sucked back into the
machine.
2. Connected securely to a plastic drain
pipe with a rubber nipple. There is no
need to use a non-return valve.
3. Connected securely to a standpipe.
4. Connected securely to a floor gully.
If required the drain hose can be
extended to a length of 5 metres. The
necessary parts can purchased from
the Miele Spare Parts Department or
your Miele dealer.
Installation
53