Connection To The Drainage System - Miele wda 201 Operating Instructions Manual

Table of Contents

Advertisement

Connection to the drainage
system
The machine drains via a drain pump
with a delivery head of 1 metre*. The
drain hose must not be kinked as this
restricts drainage. The swivel elbow at
the end of the hose can be turned in
either direction, or can be detached if
required, with a sharp twist and pull.
If required, the drain hose can be exten-
ded to a length of 5 m. The necessary
parts can be purchased from your Miele
Dealer or Miele.
* For a delivery head of more than 1 m
(up to a max. of 1.8 m) a replacement
drain pump will need to be fitted.
Please contact Miele or your Miele
Dealer for advice. If necessary, the
drain hose can be extended to a length
of 2.5 m. The necessary parts can be
purchased from your Miele Dealer or
Miele.
Drain hose connection:
1. Direct into a sink or basin.
Please note the following:
– Hook the hose over the edge and
secure.
– Make sure that the water can drain
away freely without hindrance.
Otherwise there is a risk of water
overflowing or of some of the
drained water being sucked back
into the machine.
2. Connected securely to a plastic drain
pipe with a rubber nipple. There is no
need to use a non-return valve.
Installation and connection
3. Connected securely to a floor gully.
4. Connected securely to a standpipe.
Please note:
 Adapter
 Nut
 Hose clip
 End of the hose
 Fit adapter  to the sink drain outlet
using nut .
 Attach the end of the hose  to ad-
apter .
 Use a screwdriver to tighten hose clip
 up close to the nut.
59

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents