Connection To The Drainage System - Miele WMV 960 WPS Operating Instructions Manual

Connection to the drainage
system
The machine drains via a drain pump
with a delivery head of 1.8 m. The drain
hose must not be kinked as this
restricts drainage. The swivel elbow at
the end of the hose can be turned in
either direction, or can be detached if
required, with a sharp twist and pull.
The drain hose can be extended to a
length of 2.5 m. The necessary parts
can be purchased from your Miele
dealer.
If required, the drain hose can be
extended to a length of 5 m. In this
case, the delivery head must not be
more than 1 m. The necessary parts
can be purchased from your Miele
dealer.
Drain hose connection:
1. Direct into a sink or basin.
Please note the following:
– Hook the hose over the edge and
secure.
– Make sure that the water can drain
away freely without hindrance.
Otherwise there is a risk of water
overflowing or of some of the
drained water being sucked back
into the machine.
2. Connected securely to a plastic drain
pipe with a rubber nipple. There is no
need to use a non-return valve.
3. Connected securely to a floor gully.
4. Connected securely to a standpipe.
Installation and connection
Please note:
a Adapter
b Nut
c Hose clip
d End of the hose
 Fit adapter  to the sink drain outlet
using nut .
 Attach the end of hose  to adapter
.
 Use a screwdriver to tighten hose clip
 up close to the nut.
101