4 ] Installing The Chassis Assy - Brother P-touch 65 Service Manual

[ 4 ] Installing the Chassis ASSY

(1) If the chassis ASSY has been disassembled, assemble the components, referring to
page II-20.
(2) As shown in Figure 2.2-20, fit the cutter lever onto the shaft on the chassis ASSY.
(3) Put the chassis ASSY with the cutter lever back into the bottom cover.
(4) Secure the chassis ASSY with three screws. One of those screws should also
secure the FG wire.
NOTE: Check that the FG wire is secured to the correct position, referring to the
illustration given below.
(5) Solder the motor lead wires to the main PCB as shown below.
NOTE: Check the wire ID colors, then solder the black and red wires to the (+) and (-)
points, respectively.
Figure 2.2-17 Installing the Chassis ASSY and Soldering the Motor Lead Wires
II - 18