7 ] Installing The Chassis Assy - Brother PT-1800 Service Manual

[ 7 ] Installing the Chassis ASSY

(1) Set the cutter lever to the body cover.
(2) If the chassis ASSY has been disassembled, assemble the components by referring
to the next page.
(3) Pull down the roller release lever to the vertical position and install the chassis ASSY
onto the body cover. (For making the following jobs easier, push the roller release
lever to the horizontal position.)
(4) Connect the cassette sensor cable to the main PCB.
• Be sure to lock the connector on the main PCB.
(5) Connect the drive motor harness to the main PCB, then route it through "X" so that
the harness will not become slack between its connector housing and "X."
(6) Secure the anti-static lead wire to the chassis with a screw.
Tightening torque:
(7) Connect the thermal head cable to the main PCB.
• Be sure to lock the connector on the main PCB.
490 ±196 mN•m (5 ±2 kgf•cm)
Figure 2.2-20 Installing the Chassis ASSY
II - 20