Brother MFC9700 Service Manual page 58

4) At the front end of the document feed roller shaft, remove the pawled bushing by pulling its
pawls outwards. At the rear end, pull the bushing outwards and lift up the document feed roller
ASSY.
5) At the front end of the upper LF roller (gray) shaft, remove the pawled bushing by pulling its
pawls outwards. At the rear end, pull the bushing outwards and lift up the upper LF roller ASSY.
6) Remove the two screws and take off the ADF motor.
If you do not need to remove the ADF parts, skip to step 10).
7) Peel off the ADF film.
NOTE: Once removed, the ADF film will become unusable and a new part will have to be put
back in.
8) Remove the screw and take off the spring plate A, separation rubber, rubber holder, and
compression spring.
9) Push the hooks provided on the upper ADF chute and remove the pressure rollers and their
springs.
IV - 12