Brother MFC9700 Service Manual page 168

Trouble
(3) Light
(4) Dark
At the scanner
Check the following components:
- CCD unit
- Main PCB
At the printer side
Replace the toner cartridge with a new one and print 4 to 5
l
pages. If the problem persists, proceed to the next step.
Remove the toner cartridge and start printing. If printing
l
takes place, clean the toner sensors (LED and light-receiver),
check the sensor harnesses, and then replace the toner
sensor PCBs.
Clean the high-voltage contacts for the transfer roller on the
l
drum unit, main cover, and high-voltage power supply PCB.
U
(Contacts in the illustration given on page VI-28)
Clean the high-voltage contacts for the developer roller on
l
the drum unit, main cover, and high-voltage power supply
S
PCB. (Contacts
Clean the grounding contacts on the drum unit and main
l
Q
cover. (Contacts
Check the connection of the main PCB and high-voltage
l
power supply PCB.
Replace the drum unit.
l
Replace the high-voltage power supply PCB.
l
Replace the engine PCB.
l
Replace the main PCB.
l
Replace the laser unit.
l
At the scanner
Check the following components:
- CCD unit
- Main PCB
At the printer side
Slide the wire cleaner to clean the corona wire inside the
l
drum unit.
Clean the high-voltage contacts for the grid and charger on
l
the drum unit, main cover, and high-voltage power supply
T
PCB. (Contacts
28)
Replace the toner cartridge.
l
Replace the drum unit.
l
Replace the high-voltage power supply PCB.
l
Replace the main PCB.
l
Replace the engine PCB.
l
VI - 22
Action to be taken
in the illustration given on page VI-28)
in the illustration given on page VI-28)
R
and in the illustration given on page VI-