Brother MFC9700 Service Manual page 217

Selector
No.
1
Setting of the equalizer
2
3 Sending level of guard tone at
phase 2
4 Stepping down the transmission
speed at fallback each
5 Automatic control of modem's
6 EQM gain for proper transmission
speed choice
7 Redialing when a communications
error occurs
8 Not used.
NOTE: WSW38 takes effect only in the V. 34 mode.
Selectors 1 and 2: Setting of the equalizer
These selectors set the equalizer's training level to be applied if the machine fails to send training
due to weak line connection. If these selectors are set to "0, X," the modem will automatically set
the appropriate training level.
Selector 3: Sending level of guard tone at phase 2
This selector sets the sending level of guard tone for 1800 Hz to be sent at Phase 2 in the V. 34
mode.
Selector 4: Stepping down the transmission speed at fallback each
This selector determines how much the modem steps down the transmission speed at fallback
when called by the remote station. If this selector is set to "1," the modem may step down the
transmission speed from 33600 bps to 28800 bps by one-time fallback.
Selectors 5 and 6: Automatic control of modem's EQM gain for proper transmission speed choice
These selectors determine how the modem controls the EQM (Eye Quality Monitor) gain for proper
choice of the transmission speed, which applies if the modem selects higher transmission speed
than the possible speed so that it always repeats falling back.
WSW38 (Function setting 16)
Function
38
Setting and Specifications
No. 1 2
0 X Automatic
1 0 : Fixed to 4 points
1 1 : Fixed to 16 points
0: Normal - 7 db
0: 2400 bps 1:
No. 5 6
0 0 For higher transmission speed
than the current setting
0 1 : No change from the current
setting
1 0 : For lower transmission speed
than the current setting
1 1 : For further lower transmission
than the setting made by 1, 0
0: ON 1:
1: Normal
4800 bps
OFF