Dhcp-Related Error Messages - IBM 6648 - NetVista A40 - 128 MB RAM User Manual

Error 105 indicates that a power-on diagnostic test performed by the Ethernet
module did not execute correctly. If this error message appears, you must have
the computer serviced. Error 107 indicates that the cable from the LAN is not
securely connected to the Ethernet port on your computer. Check the cable to
ensure that it is properly connected.
Other error messages that might occur are shown in the following table.
RPL-ROM-ERR: 100 The Ethernet adapter cannot be found.
RPL-ROM-ERR: 101 The Ethernet adapter was unable to initialize.
RPL-ROM-ERR: 102 The Ethernet adapter could not be reset.
RPL-ROM-ERR: 103 There are multiple Ethernet adapters in the system. Specify the
correct serial number in NET.CFG.
RPL-ROM-ERR: 104 The Ethernet adapter EEPROM is faulty or not present.
RPL-ROM-ERR: 106 The Ethernet adapter is configured for Plug and Play in a non-Plug
and Play system.
RPL-ROM-ERR: 110 The Ethernet adapter RAM failed the memory test.

DHCP-related error messages

Error messages related to DHCP and the Ethernet adapter are shown in the
following table.
E61: Service boot canceled.
E62: Cannot initialize controller.
E63: Cannot initialize controller.
E67: Cannot initialize controller.
E6d: Cannot find BOOTP server.
E6e: Cannot start from downloaded image.
E71: Too many MTFTP packages.
M10: ARP canceled by keystroke.
M11: ARP timeout.
M20: Cannot copy memory.
M21: Cannot write to memory.
M22: Cannot write to memory.
M30: Cannot ARP TFTP address.
M31: TFTP canceled by keystroke.
M32: TFTP open timeout.
M33: Unknown TFTP opcode.
M34: TFTP read canceled by keystroke.
Chapter 6. Troubleshooting
77