Power-Management Features - IBM 6648 - NetVista A40 - 128 MB RAM User Manual

Changing the primary startup sequence
These settings control the sequence of devices used to start up your computer
when it is turned on using the power switch. The default or preset settings for
the primary startup sequence are:
First startup device
Second startup device
Third startup device
Fourth startup device
To view or change the primary or automatic power on startup sequence:
1. Start the Configuration/Setup Utility program (see "Starting and using the
Configuration/Setup Utility program" on page 29.
2. Select Start Options and press Enter.
3. Select Startup Sequence and press Enter.
4. Use the arrow keys to make your selections and press Esc until you return
to the Configuration/Setup Utility program menu.
5. Select Save Settingsfrom the Configuration/Setup Utility menu and press
Enter. Then press Esc and follow the instructions on the screen to exit from
the Configuration/Setup Utility program.
Enabling the Error Startup Sequence
You can set your computer to initiate the Error Startup Sequence when POST
detects an error by enabling this feature.
To enable the Error Startup Sequence:
1. Start the Configuration/Setup Utility program (see "Starting and using the
Configuration/Setup Utility program" on page 29).
2. Select Start Options and press Enter.
3. Select Startup Sequence from the Start Options menu and press Enter.
4. Use the arrow keys to select Error Startup Sequence and set it to Primary,
Automatic, or Disabled.
5. Press Esc until you return to the Configuration/Setup Utility menu and
press Enter to save settings. Then press Esc and follow the instruction on
the screen to exit from the Configuration/Setup Utility program.

Power-management features

Your computer comes with built-in energy-saving capabilities. You can view
and change energy-saving settings using the power-management menu in the
Configuration/Setup Utility program. This section describes the
power-management features in your computer and provides instructions for
using these features.
[Diskette drive]
[Hard disk drive]
[Network]
[Disabled]
Chapter 4. Using the Configuration/Setup Utility program
39